What Is a Rot Board on a Fence and Do You Need One?

A rot board is a horizontal board that runs along the bottom of a wood fence at ground level, between the posts, so the pickets rest on it and never touch the soil. On a rot board fence, that one board takes the ground moisture and the trimmer damage, and it can be replaced without rebuilding the fence. The idea follows a rule USDA Forest Service researchers put in five words in their guidance on wood fences: "Keep boards off the ground."
What most descriptions leave out is that the rot board itself has to be the right lumber. The American Wood Protection Association rates treated wood by Use Category. Fence pickets are typically treated to UC3B, an above-ground rating, while UC4A is the general rating for ground contact. A rot board cut from the same above-ground stock as the pickets just moves the rot down one board. This post covers what a rot board does, what it should be made of, when you need one, and how much gap to leave under a fence that does not have one.

What Does a Rot Board Do?
A rot board, also called a kickboard, is a sacrificial board. It is the part of the fence designed to wear out so the rest of it does not.
It does three jobs.
It lifts the pickets. The bottom of a picket is end grain, the cut end of the wood. Set on wet soil or buried in mulch, it stays damp. With a rot board underneath, the pickets start several inches above grade.
It closes the gap. Without a rot board, a wood fence needs clearance at the bottom to keep the pickets dry, and that clearance is a gap. The rot board fills it.
It takes the abuse. String trimmers, mower decks, shovels and kicked soccer balls hit the bottom of a fence. A thick horizontal board stands up to that better than thin picket ends.
A Michigan State extension bulletin on fence posts and lumber explains why the bottom of a fence is the trouble zone: high moisture content often occurs when wood touches the ground or is used within 18 inches of the ground surface.
What Should a Rot Board Be Made Of?
Pressure treated lumber rated for ground contact. That is the point of the board.
Check the end tag or treatment stamp. AWPA's residential guide explains that the Use Category is printed there:
UC3B: above ground, exposed
UC4A: ground contact, general use
UC4B: ground contact, heavy duty
A rot board should carry UC4A or higher. It is usually a 2-by-6 or wider, thick enough to stay straight between posts and to take a hit.
Fasteners matter too. Simpson Strong-Tie recommends stainless steel or copper and silicon bronze fasteners with treated wood that has higher copper retention levels, and warns that electroplated coatings should not be considered hot-dip galvanized. The rot board is the wettest board on the fence, so it is the first place poor fasteners show.
Cedar is not the right choice for this one piece, even on a cedar fence. Cedar's decay resistance depends on heartwood content, and the board sits in the worst spot on the fence. A treated rot board under cedar pickets is a common combination. For more on the two woods, see our wood fence installation guide for Pennsylvania homeowners.
Do You Need a Rot Board on a Fence?
It depends on the yard. A rot board earns its cost when:
The fence line is damp, shaded or slow to drain
Mulch beds, soil or sod will sit against the bottom of the fence
You have a dog that noses or digs at the fence line
You want a privacy fence with no gap at the bottom
You use a string trimmer along the fence
You can skip it when:
The ground is dry and well-drained
You are comfortable with a small gap under the pickets
The fence is a decorative picket or split rail style where the look depends on open space at the bottom
The Forest Service guidance offers a useful rule of thumb. In areas where high decay is likely, boards, pickets and other face parts should be of decay-resistant wood, either natural or treated. NOAA's 1991 to 2020 normals for Pittsburgh International Airport show 39.61 inches of precipitation and 44.1 inches of snowfall in an average year, so the bottom of a wood fence here spends a lot of time wet. Our post on how weather in Western PA affects fence materials over time covers that in detail.
How Much Gap Should Be Under a Fence Without a Rot Board?
Enough to keep the bottom dry, and no more than the fence's purpose allows.
Manufacturers of fences that do not rot still specify clearance. Jerith's installation guide for its aluminum fences says gates and sections should be installed so the bottom of the fence is about 2 to 3 inches above ground level. CertainTeed's vinyl guidelines call for 2 inches of clearance under a gate's bottom rail on level ground.
If the fence is a pool barrier, the gap has an upper limit. A Pennsylvania township handout summarizing the pool code adopted under the state's Uniform Construction Code states that the vertical clearance between grade and the bottom of the barrier shall not exceed 2 inches over surfaces that are not solid, such as grass or gravel, and 4 inches over a solid surface such as concrete. Confirm the current requirement with your building inspector.
A wood privacy fence with no rot board gets a small gap for the same reason. Ask what clearance is planned at your estimate, especially if you have a small dog.
Does a Rot Board Stop Dogs From Digging Under a Fence?
It helps, and it is not dig-proof.
A rot board removes the open gap a dog would otherwise widen. A dog that wants out has to dig under a thick board that sits at or just below grade, which is more work than pushing under picket ends.
A determined digger will still get under it. For those dogs, owners add a buried barrier along the inside of the fence line. Talk through the options at your estimate, and see what makes a good fence for pet owners in the Pittsburgh area.
How Does a Rot Board Work on a Sloped Yard?
It follows the ground, which is one of its advantages.
On a slope, fence sections either step down in level increments or follow the grade. A stepped fence leaves a triangular gap under the low end of each section. A rot board cut to follow the ground closes that triangle, so the pickets can stay level on top while the bottom of the fence stays tight to the yard.
Where the grade changes a lot within one section, two stacked rot boards are sometimes used at the low end. Our post on installing a fence on a sloped yard explains stepped and racked layouts.
Do Vinyl and Aluminum Fences Need a Rot Board?
No. A rot board solves a wood problem.
Vinyl and aluminum do not decay, so there is nothing to sacrifice. Those fences have a bottom rail that sits a few inches off the ground, as the manufacturers' clearance figures above show. If you need to close that gap for a small dog, the fix is a different panel style or a barrier at the base, not a wood board bolted to a vinyl fence.
If the reason you are reading about rot boards is that you are tired of replacing rotted pickets, it may be time to compare materials. A board on board wood fence with a rot board is one answer. A fence material that cannot rot is another.
FAQ
Is a rot board the same as a kickboard?
Yes. Both names describe the horizontal board at the bottom of a wood fence.
What lumber is used for a rot board?
Pressure treated lumber rated for ground contact. Look for AWPA Use Category UC4A or higher on the end tag.
Does a rot board touch the ground?
It sits at grade or very close to it. That is why it has to be rated for ground contact when the pickets are not.
How long does a rot board last?
It depends on drainage and the treatment level. It is the board most exposed to moisture, and it is built to be replaced without disturbing the pickets above it.
Can a rot board be added to an existing fence?
Often, if there is room between the bottom of the pickets and the ground. Where the pickets already touch the soil, they may need to be trimmed first.
Does a rot board make a fence taller?
It changes how the fence is built, not necessarily how tall it is. Municipal height limits apply to the whole fence measured from grade, rot board included.
Wood Fences Built to Handle Wet Ground
Just Fences is a locally owned fence company in Harrison City, established in 2007, that installs wood, vinyl, aluminum, chain link and custom fences across Westmoreland County and Greater Pittsburgh. Free quotes are available, and installations carry a 2-year workmanship warranty. Ask about rot boards and post options when you request a quote through the custom fences page.
Visit Just Fences or call (724) 392-4416 today. Contact us for more information.





Comments